weinor BiEasy Box Operating Manual page 4

BiConnect BiEasy Set
1 N otes on assembly and installation instructions
0 B 0 B
1.1 Q ualification
1 0 B 1 0 B
These instructions are intended for weinor retailers and partners and assume relevant
knowledge. All installation work must be performed by a trained electrician.
1.2 N otes on remote control units
1 1 B 1 1 B
Remote control units transmitting on the same frequency may disrupt reception.
•
The range of the transmitted signal is restricted by law and structural measures.
•
1.3 W arranty and liability
1 2 B 1 2 B
The general conditions and terms of sale and delivery of the manufacturer, weinor GmbH & Co.
KG shall always apply (see last page for address). Liability claims with regard to personal injury
or material damage shall be excluded if they are the result of one or more of the following
causes:
Opening the device by the customer (breaking the seal)
•
Improper use of the device
•
Improper installation, start-up or operation of the device
•
Constructional modification of the device without the written consent of the manufacturer
•
Operation of the device with improperly installed connections, defective safety equipment
•
or improperly installed protective safety and protection equipment
Non-observation of the safety regulations and instructions defined in this operating
•
manual
Operation of the device outside the range defined in the technical data.
•
1.4 S tandards and guidelines
1 3 B 1 3 B S
In the design and construction, the underlying safety and health requirements of the applicable
laws, standards and guidelines have been adhered to. All information regarding safety in this
operating manual are compliant with the laws and regulations that are currently applicable in
Germany. All instructions in this operating manual must be followed at all times without
exception. Besides the safety instructions specified in this manual, the local regulations for
accident prevention, environmental protection and occupational safety must be observed and
adhered to. The regulations and standards for the safety evaluation can be found in the EC
declaration of conformity which also contains the confirmation of safety.
Item number 117445-0000
Version 1 15.11.2013
Subject to technical modifications
Page 4/23
Main Operating Manual