Base Unit Setting; Register; Dial Mode Setting; Flash Time Setting - Binatone Veva 1210 User Manual

9. Base unit setting

Dial mode 1
setting
2
3
4
5
6
Flash time 1
setting
2
3
4
5
6
7

10. Register

Press OK button. »
V M A I L
»
Press DOWN button twice.
Press OK button to confirm.
»
Press OK button to confirm.
Press UP or DOWN button to select TONE or PULSE.
»
Press OK button. confirmation tone.
Note: When dialing in Pulse mode, press */RING
button once to temporarily switch to the tone mode
dialing. It will return to the pulse mode once the
Handset goes on hook (Temporary tone dialing feature).
»
VMAIL
Press OK button.
»
Press DOWN button twice.
Press OK button to confirm.
» F L A S H T I M E F L A S H T I M E
F L A S H T I M E F L A S H T I M E F L A S H T I M E
Press DOWN button.
»
Press OK button to confirm.
Press UP or DOWN button to select the standard
flash time (100, 25 0, 00 ms) applicable to your 6
calling area.
»
Press OK button. confirmation tone.
The Handset supplied with your Veva1210 Base
unit is pre-registered at the factory
phone will be ready for use after out-of-box.
To check whether a Handset is registered, make
sure mains power to the Base unit is switched on and
the Handset is within transmitting range. The
Handset LCD screen should show its number and the
icon.
27
B A S E B A S E B A S E B A S E B A S E
» D I A L M O D E D I A L M O D E
D I A L M O D E D I A L M O D E D I A L M O D E
T O N E T O N E T O N E T O N E T O N E
B A S E B A S E B A S E B A S E B A S E
» D I A L M O D E D I A L M O D E
D I A L M O D E D I A L M O D E D I A L M O D E
0 0 M S 0 0 M S
so that your