Table of Contents
Advertisement
INSTALLATION AND SET-UP
Read these notes before installation
Connection and
You can connect your Pegasys 8 Triple to a public exchange
conditions for use
line in the UK; or to an extension on an approved PBX using
DTMF (tone) signalling and timed-break recall (TBR).
The ringer equivalence numbers (RENs) of all instruments
(phones, fax machines, etc.) connected to an exchange line
must not add up to more than 4 — otherwise, one or more
of them may not ring and/or answer calls correctly. The
Pegasys 8 Triple has a REN of 1, and most other telephones
have a REN of 1 unless marked otherwise.
Sites for the base
The base unit should be installed where:
unit and charger
the mains adapter plug will reach a 230-V
n
pod
mains supply socket — never try to lengthen the mains
power cable
the telephone cable will reach your telephone line socket or
n
extension socket
it is not close to another telephone — this can cause radio
n
interference
it is not close to a sink, bath or shower, or anywhere else
n
where it might get wet
it is not close to other electrical equipment — fridges,
n
washing machines, microwave ovens, TVs, fluorescent
lights, etc.
To use your handsets and base unit together, you must be
able to establish a radio link between them. Be aware that:
4
switched
AC
Siting the base unit as high as possible will
n
give better results — in a two-storey house,
the best position may be on the first-floor
landing.
Any large metal object — like a refrigerator,
n
or a filing cabinet — between the handset
and base unit may block the radio signal.
Other solid structures, like walls, may reduce
n
the signal strength.
The charger pods should be installed where
the mains adapter plug will reach a 230-V
switched mains supply socket — never try to
lengthen the mains power cable. Do not
place a charger pod where it might get wet.
INSTALLATION AND SET-UP
1
Choose a suitable site for the base unit.
Make sure it is not near to another
telephone, nor to other electrical
equipment
2
Plug the mains power lead and the
telephone line cord into the back of
the base unit
3
Plug the mains adapter into a
230 V AC, 50 Hz mains socket,
with the switch on the socket
set to OFF
The Pegasys 8 Triple base unit must be used with mains adapter,
part no. XX002098D, supplied with the unit. Using any other
adapter will result in non-compliance with EN41003, and will
invalidate any approval given to this apparatus.
4
Switch on mains power at the socket
5
Connect a mains power lead into the
socket on back of each charger pod
Plug each mains adapter into a 230 V AC,
50 Hz mains socket and switch on mains
power
The charger pods do not have a connection
to the telephone line
The Pegasys 8 Triple charger pods must be used with mains
AC
adapter, part no. XX002101D, supplied with the unit. Using any
other adapter will result in non-compliance with EN41003, and
will invalidate any approval given to this apparatus.
Binatone Help Line: 0208 344 8870, 9.00 am to 5.00 pm, Monday to Friday
Connecting the base unit and chargers
RINGER
HIGH
LOW
NOTE: you can set
the base unit ringer
volume using the
switch located
between the two
cable connectors
DC 9V
5
Advertisement
Table of Contents
Need help?
Do you have a question about the Pegasys 8 Triple and is the answer not in the manual?