Reset Handset Setting To Default; Base Setting; De-Register A Handset; Change The Dial Mode - Binatone iDECT L1i System User Manual

8.1.11 Reset handset settings to default
You can reset your handset to its original default settings. After reset, all
your personal settings will be deleted, including the call list and redial list,
but your phonebook will remain unchanged.
1. Press [ Menu ] and <UP/DOWN> to scroll to HS Settings.
2. Press [ Select ] and <UP/DOWN> to scroll to HS Default.
3. Press [ Select ] and enter the 4-digit system PIN (Default 4-digit
system PIN: 0000).
4. Press [ OK ] to confirm the PIN.
Note: If the PIN code is entered incorrectly, "PIN Invalid" will display.
5. Press [ OK ] to confirm the handset default.
8.2 Base Settings
8.2.1

De-register a Handset

This operation should only be necessary if one of your handsets becomes
faulty or lost and needs to be replaced.
You will need to enter the 4-digit PIN system ( default value: 0000)
A deregistered handset will have the antenna icon flashing and
"Unregistered" on the display.
Note: You cannot de-register the handset that you are currently using.
1. Press [ Menu ] and <UP/DOWN> to scroll to Base Settings.
2. Press [ Select ] and <UP/DOWN> to scroll to Delete HS.
3. Press [ Select ] and enter the 4-digit system PIN(default value:0000).
4. Press [ OK ] and a list of all other registered handsets is displayed.
5. Press <UP/DOWN> to select the handset you want to de-register.
6. Press [ Select ] to confirm the handset de-registration.
Note: If handset de-registration is successfully done, "HS Deleted " will
display.
8.2.2

Change the dial mode

You should normally leave the dialling mode at the default setting of Tone
(also called MF or DTMF) unless the phone is connected to an old
exchange that only recognises Pulse dialling. Note: If Pulse dialling is set,
you can press the * key to switch to Tone dialling for the rest of that call.
1. Press [ Menu ] and <UP/DOWN> to scroll to Base Settings.
2. Press [Select ] and <UP/DOWN> to scroll to Dial Mode.
3. Press [Select ] and <UP/DOWN> to scroll to Tone or Pulse.
4. Press [Select] to confirm your dialling mode selection.
25