Table of Contents
Advertisement
4 SETUP AND PREPARATION BEFORE OPERATION
4 SETUP AND PREPARATION BEFORE OPERATION
4.1 Pre-Operation Procedure
4
4.2 Precautions When Handling
CAUTION
This section explains the preparatory procedure for operating the AJ65SBT-64AD.
START
Create a program.
(When making offset/gain setting, set all
channels to any of user range settings 1 to 3
in the sequence program.)
Make offset/gain setting?
Yes
Offset/gain setting (Refer to Section 4.4.)
END
The precautions when handling the AJ65SBT-64AD are described below:
Do not touch the terminals while power is on. Doing so can cause a malfunction.
Ensure that no foreign matter such as chips and wire-offcuts enter the module.
Foreign matter can cause a fire, failure or malfunction.
Do not disassemble or modify the module.
Doing so can cause a failure, malfunction, injury or fire.
Do not touch the conductive and electronic parts of the module directly.
Doing so can cause the module to malfunction or fail.
Do not drop or apply any strong impact to the module.
Doing so may damage the module.
Do not touch the conductive parts of the module directly.
Doing so can cause the module to malfunction or fail.
Tighten the terminal screws within the specified torque range.
Undertightening can cause a short circuit or malfunction.
Overtightening can cause a short circuit or malfunction due to damage of the
screws or module.
Dispose of the product as industrial waste.
.......Refer to Chapter 5.
No
Start data link.
4 - 1
MELSEC-A
Advertisement
Table of Contents
