Makita HP2030 Instruction Manual page 7

Depth gauge
The depth gauge is convenient for drilling
holes of uniform depth. Loosen the side
grip and insert the depth gauge into the
hole in the side grip. Adjust the depth
gauge to the desired depth and tighten the
side grip.
NOTE :
The depth gauge cannot be used
at
the position where the depth gauge strikes against the
gear housing.
Switch action
CAUTION :
Before plugging in the tool, always check to see that the switch tirgger actuates properly
and returns to the "OFF" position when released.
To start the tool, simply pull the trigger.
Tool
speed
is
increased by increasing pres-
sure on the trigger. Release the trigger to
stop.
For continous operation, pull the trigger
and then push in the lock button. To stop
the tool from the locked position, pull the
trigger fully, then release it.
Reversing switch lever
-
7