Canon Shift Tray-E1 Service Manual page 19

4
x2
9. Remove the Reinforcing Plate.
•
Screw (RS Tightening; M4x20)
Removing the Shift Tray Driver PCB
1. Free the 2 retaining claws [1], and detach the cable retaining plate [2].
4
F-4-19 F-4-19
Protrusion
F-4-20 F-4-20
[2]
[1]
2. Remove the 2 screws [3], and detach the 2 tray full sensors [4] and the 2 grounding wires.
3. Free the cable of the tray full sensor from the clamp [5], and disconnect the connector [6].
4-9
F-4-21 F-4-21
4-9