Canon Shift Tray-E1 Service Manual page 15

4
8. Remove the Reinforcing Plate.
•
Screw (RS Tightening; M4x20)
x2
9. Remove the Reinforcing Plate.
•
Screw (RS Tightening; M4x20)
4
F-4-10 F-4-10
Protrusion
F-4-11 F-4-11
Removing the Tray Drive Unit
1. Free the 2 retaining claws [1], and detach the cable retaining plate [2].
[2]
[1]
2. Remove the 2 screws [3], and detach the 2 tray full sensors [4] and the 2 grounding wires.
3. Free the cable of the tray full sensor from the clamp [5], and disconnect the connector [6].
4-5
F-4-12 F-4-12
4-5