Front Panel - DCS Scarlatti DAC User Manual

dCS Scarlatti DAC User Manual
F P
RONT ANEL
POWER DISPLAY
S c a r la t t i
A B C D E
POWER Button
To switch on, ensure the rear panel switch is set to
panel once. Note that the unit cannot be turned on from the remote control.
To set the unit to sleep mode, press the
over the button will light, and the analogue outputs will mute, but the unit will remain close to running
temperature. Press again to return to normal operation.
To switch off, hold down the
display, then release it.
When the menu is open, press the
DISPLAY Button
Press the DISPLAY button (B) to turn the main display off and on. When the display is off, the LED
over the button will light to warn you that the unit is running.
SYNC Button
Use the SYNC button (C) to set the sync mode for the digital input that is currently selected. The DAC
remembers the Sync setting separately for each digital input. The options are:
Audio
Use this setting for systems that do not have a Scarlatti Transport. This
arrangement does NOT give the best jitter performance or the best sound quality.
WClk – The DAC locks to an external clock connected to the
This is the normal setting if you are using a Scarlatti Transport or have the full
stack. For the very best sound quality, use the this setting with the full stack.
Master
on the
mode operation, the source equipment MUST be locked to the DAC. This is the
recommended setting if you have a Scarlatti Transport, but not a Scarlatti Clock.
Flename: Scarlatti DAC Manual v1_0x.doc
SYNC FILTER INPUT
Figure 4 – Front panel
POWER
POWER button for about 5 seconds until
POWER button to close the menu.
– The DAC extracts the clock from the selected digital input and locks to it.
– The DAC uses its own stable 44.1kHz clock and outputs the same clock
WClk Output, so that the source can lock to the DAC. For correct master
F
I and press the
button once. The main display will turn off, the LED
Page 12
Software Issue 1.0x
June 2008
MUTE MENU
dCS
G H I J
POWER button (A) on the front
Power Down appears on the
Word Clock Input.
English version