Download Print this page

Sanyo VHR-390 Instruction Manual page 4

Hide thumbs Also See for VHR-390:

Advertisement

CONNECTIONS
I
Aerial/RF connection
OUnplug
the aerial cable from your TV receiver and
reconnect it to the terminal marked
ANT IN
on the VCR.
@Connect
the aerial output cable supplied as an accessory
with the VCR to the
ANT OUT
terminal on the VCR.
oConnect
the other end of this aerial output cable to the TV
receiver.
O Plug the power cord into the VCR power socket before
using the unit. Insert the plug straight and firmly.
O Insert the plug of the power cord into the wall socket.
Both video and audio (monaural) signals are fed to the TV
receiver and can be viewed by setting the TV receiver to your
preset video channel. (See page 4.)
I
AV connection
If your TV receiver has a video/audio input terminals, the
following AV connections are also possible. The AV cable is
sold separately.
.
Connect the
AUDIOMDEO OUT
terminals on the VCR to
the video/audio terminals on the TV receiver.
Both video and audio signals are fed to the TV receiver.
The advantage of this connection is a higher quality of
picture and sound during playback.
If you play back a tape, set to the TV receiver to the AV
mode.
Note:
To switch the'TV input mode, refer to the instruction
manual of the TV.
220-2
AC
D
Hi-Fi audio connection
I
To listen to the sound from the VCR over an audio system,
connect the
AUDIO OUT IJR
terminals to the input
terminals on the audio system.
The connecting cable is sold separately.
220-240V AC
m
~~~
&;
q
l-.-.IE
' '" ":':";
Remote control batteries insertion
OOpen
the lid.
@insert
2 "AA (IEC R6)" 1.5 volts batteries according to the
@ and 0 signs.
@Replace
the lid.
Notes:
Operate the remote control unit within a range of approx.
30" from the front of the VCR.
Operate the unit within approx. 6 m (20 ft) from the front of
the VCR.
The battery life under normal operating conditions is about
six months. If the batteries become weak, the operating
distance will decrease; when this occurs, replace both
batteries.
If the remote control unit is not to be used for a long period
of time, remove the batteries.
..
3

Advertisement

loading