Reclining Seat; Armrest Width Adjustment; Armrest Angle Adjustment; Foot Platform Height Adjustment - Pride Mobility JAZZY 1103 ULTRA Owner's Manual

V . C O M F O R T

Reclining Seat

If your power chair is equipped with a reclining seat, you
can adjust the seatback angle with the seatback release
lever. The lever is located on the right side of the seat
base. See figure 5.
To adjust the recline angle:
1. Pull up on the seatback release lever.
2. Lean forward or backward to the desired position.
3. Release the lever.

Armrest Width Adjustment

You can change each armrest's width independently of
the other.
NOTE: Changing the armrest width may increase the
overall width of your power chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the
armrest receiver bracket. See figure 16.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.

Armrest Angle Adjustment

To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to
the floor. See figure 16.
2. Loosen the jam nut.
3. Turn the adjusting screw clockwise to raise the front of
the armrest, or turn the adjusting screw counterclock-
wise to lower the front of the armrest.
4. Tighten the jam nut to lock the adjusting screw into
place.

Foot Platform Height Adjustment

The foot platform height is easily adjusted to different heights
in 1/2-in. increments.
To raise or lower the foot platform:
1. Remove the quick release fasteners from the foot
platform bracket. See figure 17.
2. Raise or lower the foot platform to the desired height.
3. Reinstall the quick release fasteners into the foot
platform bracket and tighten.
Jazzy 1103 Ultra
A D J U S T M E N T S
FOOT PLATFORM BRACKET
Figure 17. Foot Platform Adjustment
UNCLAMPED
Figure 18. Quick Release Fastener Operation
www.pridemobility.com
QUICK RELEASE FASTENERS
NUT
BOLT
LEVER (OPEN)
FOOT PLATFORM
RETAINING PIN
LEVER (FULLY CLOSED)
CAM
CLAMPED
25