Reclining Seat; Armrest Angle Adjustment - Pride Mobility JAZZY 1170 XL Owner's Manual

I V . C O M F O R T
10. Reinstall the seat.
11. Plug the connectors into the electronics tray.

Reclining Seat

If your Jazzy is equipped with a reclining seat, you can adjust
the seatback angle with the seatback release lever. The lever
is located on the right side of the seat base.
To adjust the seatback angle:
1. Press down on the lever.
2. Move the seatback down or up to the desired position.
3. Release the lever.
Seatback Angle
If your Jazzy is equipped with an adjustable seatback, you
can adjust it to four (4) different angles: 90°, 102°, 105°, or
107°. See figure 11.
To adjust the seatback angle:
1. Remove the adjusting screws on both seat hinges.
2. Set the seatback at desired angle.
3. Reinstall the screws on both seat hinges and tighten.
Armrest Width Adjustment
You can change each armrest's width independently of each
other.
NOTE: Changing the armrest width may increase the over-
all width of your Jazzy.
To change the armrest width:
1. Locate the two knobs on each side of the armrest receiver
bracket. See figure 11.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.

Armrest Angle Adjustment

To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to
the floor.
2. Loosen the jam nuts. See figure 12.
3. Loosen the adjusting screw.
20
A D J U S T M E N T S
www.pridemobility.com
REMOVE THIS
SCREW ON EACH
SIDE OF
THE SEAT TO
CHANGE THE
SEATBACK ANGLE.
LOOSEN TO
CHANGE
ARMREST WIDTH.
Figure 11. Seatback and Armrest
Adjustments
TURN THIS SCREW TO CHANGE ARMREST ANGLE.
JAM NUTS
LOCK
ADJUSTING
SCREW IN
PLACE.
Figure 12. Armrest Angle Adjustment
Jazzy 1170XL