Digisol SKYROS SERIES Quick Installation Manual page 5

Camera Installation - Hardware
Please follow the instructions mentioned below to setup your
new IP camera.
Connect Ethernet cable to the LAN port.
DC Power Input
Ethernet Port
Plug DC power adapter to the power outlet on the wall. Connect DC power cable to IP
Camera's DC power connector.
If everything's OK , you should see the left LED light on LAN port light up. If not,
please recheck every step and try again, or ask your dealer of purchase for help.
If this IP Bullet camera is connected to a PoE switch then the device can be powered
on without using the power adapter.
Camera Installation – Software
5