The Pocket Table Tool_P .Tch - HEIDENHAIN TNC 620 User Manual

The pocket table TOOL_P .TCH

The function of the pocket table depends on the
machine. Refer to your machine manual.
In the pocket table TOOL_P .TCH (permanently saved under TNC:
\TABLE\) you specify which tools your tool magazine contains.
To enter data in the pocket table TOOL_P .TCH, proceed as follows:
Display the tool table
Display the pocket table
Edit the pocket table: Set the EDITING soft key to
ON
With the upward or downward arrow keys you can
select the pocket number that you want to edit
With the rightward or leftward arrow keys you can
select the data that you want to edit
To leave the pocket table, press the END key
Further information on this topic
Operating modes of the TNC: See "Modes of Operation",
page 71
Working with the pocket table: See "Pocket table for tool
changer", page 157
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 5/2013
Setting up tools
1
1.5
61