Dürkopp Adler 867 Service Instructions Manual page 94

4. Call up the technician level using the Plus/Minus keys (3):
5. Press the OK key (5)
Fig. 69: Setting the potentiometer
6. Check whether the lifting gear plates are flush.
7. Loosen the setscrews (1).
8. Set the connecting clamp (2) for the lifting cylinder such that the plates
9. Tighten the setscrews (1).
10. Loosen the setscrew (3).
11. Turn the potentiometer axle such that the left display shows 1 in the
12. Tighten the setscrew (3) without changing the value shown in the dis-
13. Press the ESC key two times.
Important:
14. Switch off the machine at the main switch.
15. Switch on the machine at the main switch.
 Switching off and on will save the setting.
92
As the case may be, press the Plus or Minus key under the letter or
the number until the display indicates t 10 04.
(1) - Setscrews
(2) - Connecting clamp for lifting cylinder
If the plates are not flush:
are flush.
first instance and the relevant maximum speed next to it.
play.
Setting the potentiometer
(3) - Setscrew for the setting shaft
(4) - Potentiometer
Service Instructions 867 - 03.0 - 10/2017