Dürkopp Adler 867 Service Instructions Manual page 78

2. Push the clamping ring (1) as far as it will go to the left.
3. Tighten all four setscrews (2) on the clamping ring (1).
4. Loosen the setscrews (5).
5. Press the actuating lever (7) against the solenoid (9).
6. Turn the control cam (4) such that its widest extent (6) is at the top,
7. Move the control cam (4) such that the distance between its widest
8. Tighten the setscrews (5).
9. Loosen the clamping screw (8) on the actuating lever (7).
Fig. 58: Aligning the thread-pulling knife sideways - Part 2
^
(10) - Screw
(11) - Counter-blade
(12) - Thread-pulling knife
10. Turn the thread-pulling knife (12) such that the circle mark is exactly
11. Tighten the clamping screw (8) on the actuating lever (7) such that the
12. Loosen all four setscrews (2) on the clamping ring (1).
13. Push the clamping ring (1) to the right as far as it will go and against
14. Check the loop stroke position ( S. 52).
15. Tighten all four setscrews (2) on the clamping ring (1).
76
Screw the four setscrews (2) tightly in place on the clamping ring (1)
before you loosen the setscrews (5). The clamping ring (1) and con-
trol cam (4) are both mutually used as a stop and should not be un-
done at the same time.
next to the roller (3).
extent (6) and the roller (3) is 0.1 mm at most.
next to the tip of the counter-blade (11).
actuating lever (7) has no axial play.
the control cam (4).
(13) - Screw
(14) - Hook thread clamp
(15) - Screw
Service Instructions 867 - 03.0 - 10/2017
Thread cutter