Table of Contents
Advertisement
KWR101803/01B
6. Universal RC Function
The 5 keys that are programmable by URC and they are listed in the following table.
Key Name
TV AV input
TV Standby
TV VOL+
TV VOL -
TV Mute
Follow the key sequence below to invoke the database feature for a key:
1
Turn on the TV.
2
Press and hold "PG+" together with "PG-" key.
The user can also press and hold a key first then press and hold the next key.
However this will cause the first key to transmit code.
3
Press and hold both keys for 3 seconds or more. Both LED on RC side will turn on.
Release the key. RC enters into Database Search mode.
4
The user can choose the following steps to perform the database search
5) Full Search (key TV Standby)
6) Step Forward (key PG+)
7) Step Backward (key PG-)
8) To store the desire codeset (key BACK)
5
Full Search:
Point the KWR at the TV.
Press and hold the POWER to start full search.
Each time a codeset is been transmitted, the TV Standby LED will blink.
When the TV response by turning off, release the POWER key.
6
Step Forward:
Point the KWR at the TV.
Press and release the PG+ to send the next codeset.
Each time a codeset is been transmitted, the TV Standby LED will blink.
When the TV response by turning off, do not continue with key PG+.
If the current codeset is the last codeset, there will be 10 blinks on the "IR" LED.
Use Step Backward to continue the search.
7
Step Backward:
Point the KWR at the TV.
Press and release the PG- to send the previous codeset.
Each time a codeset is been transmitted, the TV Standby LED will blink.
When the TV response by turning off, do not continue with key PG-.
If the current codeset is the first codeset, there will be 10 blinks on the "IR" LED.
Use Step Forward to continue the search.
8
Storing:
Once the TV is responding with the found codeset, press the BACK key to store the
codeset.
The KWR will exit the database search mode and user can start to use the desire
codeset.
Please take note of the following points when performing the database function:
a
The remote will NOT exit the database mode, except for the following occurrence:
•
If no key selected within 30 seconds.
•
If BACK key is pressed
b
User can press and release the TV STANDBY, INPUT, TV VOL+, TV VOL- and TV
MUTE to test the code.
c
The STANDBY LED will always turn ON during database mode.
d
No key is active when the LED is blinking.
Status :Draft, For Review
Philips Home Control
Key function
Change AV input source to TV
Power on/off TV
TV Volume up
TV Volume down
TV Mute
Page 10 of 10
Manual (Draft Version)
Philips Proprietary &Confidential
Company Restricted
Advertisement
Table of Contents
