Table of Contents
Advertisement
2. Hardware Description
The switch provides two different running speeds – 10Mbps and 100Mbps, and
automatically distinguishes the speed of the incoming connection.
This section describes the hardware features of the FSD-1008HP. For easier
management and control of the FSD-1008HP, familiarize yourself with its display
indicators and ports. Front panel illustrations in this chapter display the unit LED
indicators. Before connecting any network device to the FSD-1008HP, please read
this chapter carefully.
2.1 Front Panel
The Front Panel of the FSD-1008HP PoE+ Ethernet Switch consists of 10 Auto-
Sensing 10/100Mbps Ethernet RJ45 Ports. The LED Indicators are also located on
the front panel of the FSD-1008HP.
2
4
6
PWR
1
3
5
FSD-1008HP
The front panel of FSD-1008HP provides one DIP switch for Standard, VLAN
and Extend mode selections. The detailed descriptions are shown in the following
table.
DIP Switch Mode
Standard
VLAN
Extend
Standard
VLAN
Extend
2
LNK
ACT
8
PoE In-Use
PoE
7
9
10
PoE
Standard
VLAN
1
Extend
Figure 2-1: FSD-1008HP Switch Front Panel
This mode makes the FSD-1008HP operate as a general
switch and all PoE ports operate at 10/100Mbps auto-
negotiation.
This mode makes the FSD-1008HP operate as a VLAN
isolation switch and
1. Port 1 to port 8 will isolate respectively.
2. Port 1 to port 8 can only communicate with port 9 and
port 10 (uplink port).
4
6
8
8-Port 10/100TX 802.3at PoE +
2-Port 10/100TX Desktop Switch
3
5
7
9
Function
Uplink
10
9
Advertisement
Table of Contents
