Table of Contents
Advertisement
CAUTION
Contact with contact pins
Do not touch the contact pins of connectors with your hand or any metal item. Do
not any objects such as wire among the pins. Do not place the equipment in a
place where there are metal pieces. Otherwise, contact failure may cause a
malfunction.
When you have to touch the card, take care not to hurt yourself. You can wear
cotton gloves.
Addition and replacement of parts in the equipment
Increasing the number of built-in options for a system device or replacing them
must be entirely conducted by maintenance personnel. Avoid removing the cover
from the device and avoid installing or removing built-in options. The system
device contains parts mounted at high density, which suggests that unskilled work
will lead to injury or device failure. If you need to add or replace options, you
should contact your dealer or call the maintenance personnel.
Contact with metal edges
When moving the equipment or adding parts, take care not to hurt yourself on the
metal or plastic edges. You can wear cotton gloves.
Using at an unstable place
Do not place the equipment on an inclined ground or at a narrow or unstable
place. The equipment may fall and cause an injury.
Use for purposes other than the stated purpose
Do not use the equipment for any other purpose other than its intended use. It
may malfunction or fall and cause an injury.
Consumables
Only use specified consumables. Using consumables other than those specified
may not only reduce reliability of the product but also cause malfunction, electric
shock or fire.
Eye fatigue
Provide luminance of 300 to 1000 lux for viewing the display. Take a break of 10
to 15 minute every hour. Viewing the display for a long time results in eye fatigue.
Cover for the power supply module
The power supply module, and its cover and handle are heated while that module
is run. Take care when replacing a failed module or in other cases. You might get
burned.
Laser beam
On this product, a Class 1 laser product is installed. Do not look directly at the
laser beam. Do not look at the laser beam using an optical device.
Under the laser module cover, a laser beam is being emitted. Do not remove the
cover of an unused board.
xvi
Advertisement
Table of Contents
