Table of Contents
Advertisement
WARNING
Not designed to operate in a humid or dusty environment
Do not use the equipment near a place where water is used such as sink, in a
humid basement, or in a dusty place. Such conditions may lower electric
insulation, leading to electric shock or fire.
Not designed to operate in a high-temperature environment
Do not install the equipment in a place subject to high temperatures and do not
cover it with insulating material. It may cause a fire.
Moving between two locations with a significant temperature gap
When you move the equipment from one location to another, a significant
temperature gap between the two locations may cause condensation on the
surface or inside the equipment. Using the equipment when condensation is
present may lead to electric shock or fire. Leave the equipment at the new
location for several hours before you start using it.
Addition and connection of peripheral devices or optional
components
To add or connect peripheral devices or optional components to the equipment,
remove the power plug from the outlet and disconnect all cables from the
equipment unless otherwise instructed. Use only peripheral devices and optional
components which are explicitly listed as supported devices in the manual, and
always follow the instructions in the manual.
Using devices other than those mentioned above would cause a failure of the
peripheral devices or optional components, smoke, or fire due to the difference in
connection specifications.
Vents
Vents on the equipment aim to prevent internal temperature rise. Do not block the
vents by placing any objects in front of or against them. Otherwise the internal
temperature may rise, leading to smoke, fire or failure.
Keep vents clear of dust by periodically checking and cleaning them.
Plastic bags for packaging
To avoid the risk of suffocation, do not leave plastic bags (such as air bubble
cushioning for packaging) within the reach of young children.
Handling the power supply module
The power supply module has a high-voltage area in it. Do not open the cover.
It may result in electric shock or equipment failure.
Handling of the product
Install the product on a fixed rack. Do not lean against the product or stand on it.
Do not install the product in a place with weak floors and walls.
Do not subject the product to excessive vibration. It could fall and cause a failure.
xv
Advertisement
Table of Contents
