Fujitsu UTB-YCA Setting Manual page 16

Turn on power
Setting of central remote
controller address
System information
scanning
Automatic storing
Manual storing 1
Manual storing 2
Version display
Note
• When in initial setting mode,
• Unless "(2) System information scanning" or "(3) Indoor unit storing" have been completed, initial setting
mode will not end even if SW42 is pressed.
Always wait one minute or more after performing the operations for turning on the power shown in "3-
2-1. Turn on power" before performing the initial settings. If initial settings are performed after the
power is turned on and before the outdoor and indoor unit system data has been created, an error will
occur.
14
Initial setting Clock setting
XXXX.XX
will light up.
Group information store Test operation