Setup And Operating Procedures; Get The Application For Hs4; Installing Batteries - iHealth HS4 Operation Manual

—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
15.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause
interference, and(2) this device must accept any interference, including interference that
may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
This ClassÿBÿ digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme
NMB-003 du Canada.

SETUP AND OPERATING PROCEDURES

1. GET THE APPLICATION FOR HS4

The scale works with an iPod Touch, iPhone, and iPa d. You will first need to install the
application (app). If you have not installed it yet , please proceed as follows to download the
app.
You can download the HS4 app from the App Store usi
Ensure that you have access to the internet.
a. Connect your iOS device to the HS4 as described in section 4 below. If the app is not
available, the system will display "Application Not Installed". Please choose "yes" and follow
the on-screen instructions to download the app for free.
b. Launch the App Store and perform a search using the key words "iHealth", "HS4" or
"Wireless Scale" to locate the app. Download the ap propriate app and then install it. The icon
should look like this.

2. INSTALLING BATTERIES

a. Open the battery cover on the back of the scale.
b. Install four "AAA" batteries. Check that the bat
c. Close the battery cover.
ng one of processes described below.
tery polarity is correct.
5
Template version:1