Wireless Body Analysis Scale (HS5) OWNER’S MANUAL Table of Contents INTRODUCTION PACKAGE CONTENTS INTENDED USE IMPORTANT NOTE FOR USERS CONTRAINDICATION PARTS AND DISPLAY INDICATORS SET UP REQUIREMENTS SET UP PROCEDURES SET UP THE SCALE’S WI-FI CONNECTION MEASUREMENT INSTRUCTIONS SPECIFICATIONS GENERAL SAFETY AND PRECAUTIONS...
INTRODUCTION Thank you for purchasing the iHealth Wireless Body Analysis Scale. You will now be able to measure, track, and share vital body composition parameters from the comfort of your home. In addition to body weight, the iHealth Wireless Body Analysis Scale measures: •...
IMPORTANT NOTE FOR USERS Pregnant women need to consult their healthcare provider before use. Some physical conditions could affect hydration levels that may lead to inaccurate results. Please consult your healthcare provider for more information. Always store the iHealth Wireless Body Analysis Scale in a dry place.
User Body Fat Wirless Signal Settings SET UP REQUIREMENTS The iHealth Wireless Body Analysis Scale is designed to be used with the following iPod touch, iPhone and iPad models: iPod touch (5th generation) iPod touch (4th generation) iPhone 5 iPhone 4S iPhone 4 iPad mini iPad (4th generation)
and WPA2 personal security modes. Install Batteries Open the battery cover on the back of the Scale and insert four “AA” batteries. If “Lo” appears on the LED, replace all the batteries. Rechargeable batteries are not suitable for this Scale. To avoid damage as a result of battery leakage, remove the batteries if the Scale is not going to be used for 3 months or more.
STEP 4: Select “Allow” in the pop-up window, as shown below. STEP 5: The wireless signal icon on the Scale’s display will flash for a few seconds and then stabilize when Wi-Fi connection is successful. The Scale should display as shown below.
Page 8
Taking Measurements Without iOS Device Up to 20 people can use the Scale. The Scale determines who the...
Page 9
user is by matching the new weight with weight previously recorded. If the weight of two or more users is similar, the Scale will display the user number (e.g. User # “x”). Step lightly on the lower left corner to select the appropriate user, and then step lightly on the lower right corner to confirm.
GENERAL SAFETY AND PRECAUTIONS 1. Read all of the information in the Owner’s Manual and other included product information in the packaging before operating this product. 2. Please stand on the Scale with bare feet, keeping as still as possible until the results appear on the display. Do not stand on the edge of the Scale as you may fall or receive inaccurate measurements.
interference that may cause undesired operation. 15. Changes or modifications not expressly approved by iHealth Lab Inc. invalidate the user’s warranty for this equipment. 16. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
Page 13
Bluetooth connection failed 1 Turn off and turn on the Bluetooth, and re-establish the Bluetooth connection. 2 If the problem persists, restart your iOS device. Wi-Fi sharing pop-up window Re-establish the Bluetooth doesn’t show on the iOS device connection “ ”Wi-Fi symbol doesn’t 1 Make sure iOS device is connected appear on the Scale display...
The Scale displays “Er 5” Make sure Scale is connected to a router. Make sure router is connected to internet. The Scale displays “- - - -” The Scale failed to detect body impedance. Make sure you step on all four electrodes with bare feet, and try again.
Page 15
Symbol for “TYPE BF APPLIED PARTS” Symbol for“ENVIRONMENT PROTECTION – Waste electrical products should not be disposed of with house- hold waste. Please recycle where facilities exist. Check with your local Authority or retailer for recycling advice”. Symbol for “MANUFACTURER” Symbol for “KEEP DRY”...