Insignia 9015 Assembly & Fitting Instructions page 14

Steam shower

Enlarged version

Connecting the steam generator

Fitted at the bottom of the shower rear you will find the steam

generator which will look similar to the picture below. Connect

white insulated hose to the shower steam pod. This is located

below the seat in the cabin and connection is at the rear for ease.

Check now by picture or words written on the generator box,

"Water In" This will connect to the middle braided hose found

coupled to the rear of the water valve you just tighten connections

to. Finally if the fitting kit was purchased couple the last connec-

tion which is "Steam Generator water waste" This goes from the

generator to the shower tray spigot mentioned at the earliest stage

(Remember? You drilled this out!). If no waste purchased you will

need to make your own arrangements to connect somewhere else

into the house waste or call 0844 800 3069 to order the special

waste. Remember to tighten all connections

See typical set up overleaf.....

For the latest fitting instructions please visit www.insigniarange.co.uk

Important!

Never use the steam gen-

erator with the vent holes

pointing towards the

shower wall or a person.

Never use the steam out-

let in the closed position.

This excessive heat will

damage your tub and this

is NOT covered under

your warranty terms.

What Should I Know About Steam Room Safety?

Please visit the following link:

http://www.insigniarange.co.uk/instructions/

Steam_Safety_Please_Read.pdf

Checked neoprene seals are in

position?

For the latest fitting instructions please visit www.insigniarange.co.uk

Water In

Steam Out

Drain/Water Out

Steam Outlet