Entering User Modes; Power Adapter; Energy Saver Feature - HP OMEN W9S97AA User Manual

Preset Timing name
2 576p
3 720p50
4 720p60
5 1080p60
6 1080p50

Entering user modes

The video controller signal may occasionally call for a mode that is not preset if:
You are not using a standard graphics adapter.
●
You are not using a preset mode.
●
If this occurs, you may need to readjust the parameters of the monitor screen by using the on-screen display.
Your changes can be made to any or all of these modes and saved in memory. The monitor automatically
stores the new setting, and then recognizes the new mode just as it does a preset mode. In addition to the
factory preset modes, there are at least 10 user modes that can be entered and stored.

Power adapter

Manufacturer
Chicony

Energy saver feature

The monitor supports a reduced power state. The reduced power state will be entered into if the monitor
detects the absence of either the horizontal sync signal and/or the vertical sync signal. Upon detecting the
absence of these signals, the monitor screen is blanked, the backlight is turned off, and the power light turns
amber. When the monitor is in the reduced power state, the monitor will utilize <0.5 watts of power. There is
a brief warm-up period before the monitor will return to its normal operating state.
Refer to the computer manual for instructions on setting the energy saver mode (sometimes called power
management feature).
NOTE: The above power saver feature only works when connected to computers that have energy saver
modes.
By selecting the settings in the monitor's Sleep Timer utility, you can also program the monitor to enter into
the reduced power state at a predetermined time. When the monitor's Sleep Timer utility causes the monitor
to enter the reduced power state, the power light blinks amber.
22 Appendix A Technical specifications
Pixel format Horz freq (kHz)
720 × 576 31.25
1280 × 720 37.5
1280 × 720 45
1920 × 1080 67.5
1920 × 1080 56.25
Model number
TPC-CA57
Vert freq (Hz)
50
50
60
60
50
Power supply rating
19.5 V dc @ 4.62 A – 90 W