Attaching The Vesa Mounting Bracket - HP OMEN W9S97AA User Manual

Attaching the VESA mounting bracket

A VESA mounting bracket is included with the monitor for use when attaching the display head to a wall,
swing arm, or other mounting fixture.
1. Remove the monitor stand. Refer to
2. Remove the screw from the center of the rear of the display head.
3. Insert the tab at the bottom of the VESA bracket into the slot on the back of the display head until the
bracket clicks in place (1), and then secure the top of the bracket with the screw that was installed in the
center of the display head (2).
4. To attach the display head to a swing arm or other mounting device, insert four mounting screws
through the holes on the mounting device and into the screw holes on the VESA bracket that was
installed on the rear of the display head.
Removing the monitor stand on page 10.
Setting up the monitor 11