Mounting The Display Head; Removing The Monitor Stand - HP OMEN W9S97AA User Manual

Mounting the display head

The display head can be attached to a wall, swing arm, or other mounting fixture.
NOTE: This apparatus is intended to be supported by UL or CSA Listed wall mount bracket.
CAUTION:
party mounting solution to the display head, four 4 mm, 0.7 pitch, and 10 mm long screws are required.
Longer screws must not be used because they may damage the display head. It is important to verify that the
manufacturer's mounting solution is compliant with the VESA standard and is rated to support the weight of
the display head. For best performance, it is important to use the power and video cables provided with the
monitor.

Removing the monitor stand

You can remove the display head from the stand to install the display head on a wall, a swing arm, or other
mounting fixture.
CAUTION:
disconnected.
1. Disconnect and remove all cables from the monitor.
2. Lay the monitor face down on a flat surface covered by a clean, dry cloth.
3. Press down on the release latch (1) and slide the stand out of the slot on the display head (2).
10 Chapter 1 Getting Started
This monitor supports the VESA industry standard 100 mm mounting holes. To attach a third-
Before beginning to disassemble the monitor, be sure the monitor is turned off and all cables are