Installation Instructions - Bosch Rexroth A2FM series Instruction Manual

Installation instructions

General
The axial piston unit must be filled with hydraulic fluid and
air bled during commissioning and operation. This must
also be observed following a longer standstill as the axial
piston unit may empty via the hydraulic lines.
The leakage in the housing area must be directed to the
reservoir via the highest drain port (T
drain line is used for several units, make sure that the
respective case pressure is not exceeded. The shared drain
line must be dimensioned to ensure that the maximum
permissible case pressure of all connected units is not
exceeded in any operating conditions, specifically on cold
start. If this is not possible, separate reservoir lines must
be laid as required.
To achieve favorable noise values, decouple all connecting
lines using elastic elements and avoid above‑reservoir
installation.
In all operating conditions, the drain line must flow into the
reservoir below the minimum fluid level.
Key
F Filling / air bleeding
R
Air bleed (special version)
U Bearing flushing / air bleed port
T , T Drain port
1 2
h Minimum required immersion depth (200 mm)
t min
h Minimum required distance to reservoir bottom (100 mm)
min
, T ). If a shared
1 2
Axial piston fixed motor | A2FM for explosive areas
Installation position
See the following examples 1 to 6.
Further installation positions are available upon request.
Recommended installation position: 1 and 2
Below-reservoir installation (standard)
Below‑reservoir installation means that the axial piston unit
is installed outside of the reservoir and below the minimum
fluid level of the reservoir.
Installation position
1
T
1
2
T
2
3
h
t min
h
min
T
1
RE 91001-01-X-B2/01.2016, Bosch Rexroth AG
Installation instructions
Air bleed Filling
– T
1
h
t min
h
min
– T
2
h
t min
h
min
– T
1
27