Elcometer 456 Ultra Manual page 4

R
4 SPARES
Probe end caps wear over time and the gauge will inform the user during the calibration procedure if the cap
f
needs replacing . When tested using smooth surfaces, probe end caps have been scanned in excess of 50km
(30 miles). Replacement caps are available to purchase from Elcometer or your local supplier.
Description
Replacement Ultra/Scan Probe End Caps (3 per pack)
Replacement Foil Set; Scale 1; 0 - 1500µm (0 - 60mils)
Replacement Foil Set; Scale 1; 0 - 1500µm (0 - 60mils) - Certified
Replacement Foil Set; Scale 2; 0 - 5mm (0 - 200mils)
Replacement Foil Set; Scale 2; 0 - 5mm (0 - 200mils) - Certified
Ferrous Zero Test Plate, 1%
Non-Ferrous Zero Test Plate, 1%
5 IMPORTANT INFORMATION
"Scan" and "Auto Repeat" modes are only available on Elcometer 456 Model T separate gauges. The probe end
cap must be fitted to the Ultra/Scan Probe when used in these modes to avoid damage to the probe tip. Use in
these modes without the cap will invalidate the probe warranty.
The Ultra/Scan Probes can be used in "Standard" mode - with or without the probe end cap fitted - when
connected to any Elcometer 456 separate gauge.
When fitted with the probe end cap, the Ultra/Scan Probes are not recommended for use on coating thicknesses
below 100
µm (4mils).
f
When the cap thickness falls below 200µm (8mils)
is a registered trademark of Elcometer Limited, Edge Lane, Manchester, M43 6BU. United Kingdom
R
© Elcometer Limited 2013 - 2015. All rights reserved. No part of this document may be reproduced, transmitted, transcribed, stored (in a retrieval system or otherwise) or
translated into any language, in any form or by any means (electronic, mechanical, magnetic, optical, manual or otherwise) without the prior written permission of
Elcometer Limited
Sales Part Number
T456C23956
T99022255-1
T99022255-1C
T99022255-2
T99022255-2C
T9994910-
T9994911-
TMA-0568 Issue 03 - Text with cover 23959