Water Inlet; Water Drainage - Zanussi ZWI71209WA User Manual

WATER INLET

• The inlet hose is supplied with the appliance
and can been found inside the appliance drum.
• Do not use the hose from your previous
appliance to connect to the water supply.
This appliance must be connected toa
cold water supply.
45˚
35˚
• Set the hose correctly by loosening the ring nut.
After positioning the inlet hose, be sure to tight-
en the ring nut again to prevent leaks.
• The inlet hose must not be lengthened. If it is
too short and you do not wish to move the tap,
you will have to purchase a new, longer hose
specially designed for this type of use.

WATER DRAINAGE

The end of the drain hose can be positioned in
three ways:
• Connect the hose
with the angled con-
nection to the ma-
chine. Do not place
the inlet hose down-
wards.
• Angle the hose to the
left or right depending
on the position of your
water tap.
• Connect the hose to a
tap with a 3/4"thread.
Always use the hose
supplied with the ap-
pliance.
• Hooked over the edge of a sink using the
plastic hose guide supplied with the
machine.
In this case, make sure the end cannot come
unhooked when the appliance is emptying. This
could be done by tying it to the tap with a piece
of string or attaching it to the wall.
• In a sink drain pipe branch.
This branch must be above the trap so that the
bend is at least 60 cm above the ground.
• Directly into a drain pipe at a height of not
less than 60 cm and not more than 90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the
drainpipe must be larger than the outside
diameter of the drain hose. The drain hose must
not be kinked.
The drain hose may be extended to a maximum of 4
metres. An additional drain hose and joining piece
is available from your local Service Centre
19