Emergency Emptying Out; Troubleshooting; Possible Failures - Zanussi ZWI71209WA User Manual

EMERGENCY EMPTYING OUT

If the appliance does not drain the water, proceed
as follows:
1. Disconnect the mains plug from the mains
socket.
2. Close the water tap.
3. If necessary, wait until the water has cooled
down.
4. Place a bowl on the floor and put the end of
the emergency emptying hose into the bowl.
Remove its cap.

TROUBLESHOOTING

WARNING! Refer to Safety chapters.
INTRODUCTION
The start of the appliance does not occur or it
stops during operation.
First try to find a solution to the problem (refer to
the table). If not, contact the Authorised Service
Centre.
With some problems, the acoustic signals
operate and the display shows an alarm
code:

POSSIBLE FAILURES

Problem
The programme does not
start.
The appliance does not fill
with water properly.
16
The water should drain by gravity into the bowl.
5. When the bowl is full, put the cap back on the
6. Empty the bowl. Repeat the procedure until
7. Clean the pump if necessary as previously
8. Replace the emergency emptying hose in its
9. Screw the water inlet hose back on.
•
•
•
•
• Make sure that the mains plug is connected to the mains socket.
• Make sure that the appliance door is closed.
• Make sure that there is not a damaged fuse in the fuse box.
• Make sure that the Start/Pause has been pressed.
• Deactivate the Child Lock function if it is on (if available).
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too low. For
this information, contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter of the inlet hose and the filter of the valve
are not clogged. Refer to "Care and cleaning".
• Make sure that the inlet hose has no kinks or bends.
• Make sure that the connection of the water inlet hose is correct.
• Make sure that the drain hose is in the correct position. The hose
may be too low.
emergency hose.
water stops flowing out.
described.
seat after having plugged it.
- The appliance does not fill with water
properly.
- The appliance does not drain the water.
- The appliance door is open or not
closed correctly. Please check the door!
- The mains supply is unstable. Wait until
the mains supply is stable.
WARNING! Deactivate the appliance
before you do the checks.
Possible solution