Advertisement
Back Panel
Please make sure the Power pass-through current does not exceed 10 Amps
Features
•
Strong aluminium chassis with small profile
•
DMX512 Controllable and RDM Configurable
Can use up to 12 DMX channels, depending on
•
configuration
•
Snapshots: 64 fully user recordable slots, 50
different pre-loaded stand-alone colours
16-bit or Smart 8-bit LED dimming
•
ET Mk2
5 C O L O U R H I G H P O W E R L E D L I G H T B A R
300mm/600mm/1200mm
Covered by US patent 08950901
Strobe Mode with controllable frequency from DMX
•
•
Fan-less smart heat management
Easy addressing and configuration interface
•
•
180° Adjustable mounting bracket
User Manual
Document PN: 50847
www.enttec.com
1
Advertisement
Table of Contents
Related Manuals for Enttec ET Mk2
Summary of Contents for Enttec ET Mk2
-
Page 1: User Manual
User Manual Document PN: 50847 www.enttec.com ET Mk2 5 C O L O U R H I G H P O W E R L E D L I G H T B A R 300mm/600mm/1200mm Back Panel Please make sure the Power pass-through current does not exceed 10 Amps... - Page 2 Cleaning Control Panel It is important to clean the ALEPH2 ET Mk2 to maintain a After powering up, the current firmware version is long service life. Make sure the unit is unplugged before displayed, followed by the DMX Start Address.
- Page 3 5 - EXTENDED (9 CHANNEL) MODE This extended mode offers a wide variety of output effects, turning the ALEPH2 ET Mk2 into a very versatile unit, using 9 DMX channels, as described in the following chart. 2 – 8BIT RGBW MODE (4 Channel)
-
Page 4: Presets Menu
6 – 8BIT 1CHANNEL MODE This mode turns the Aleph 2 ET Mk2 into a single colour, single channel dimmer. The output colour is not any specific kind of white and this mode is not tuned up to produce balanced output. -
Page 5: Firmware Version
Updating the firmware of the ALEPH2 ET Mk2 requires an all the presets to the original values and user recorded ENTTEC USB Pro or a Pro Mk2 USB interface plugged in to a presets will not be recoverable. PC USB port. Connect the USB PRO to the ET through a standard 5 pin DMX cable. -
Page 6: Colour Gamut
Version ID” RDM field or navigate to the Firmware Version menu using the control panel. RDM Capabilities The ALEPH2 ET Mk2 supports RDM features and any RDM Controller can be used to configure it using RDM. The “ENTTEC RDM Controller” free App can be downloaded from ENTTEC website and be used in combination with a DMX USB PRO or a PRO MK2 widget. -
Page 7: Ordering Information
Ordering Information Dimensions Registration Please register your ENTTEC product to get latest software updates and to validate your warranty. To register, please visit enttec.com/register Email: s a l e s @ e n t t e c . c o m Website: www.enttec.com...
Need help?
Do you have a question about the ET Mk2 and is the answer not in the manual?
Questions and answers