Configuring Audio Playback Ports (Headphone) - Toshiba dynadock WiAC User Manual

TM
dynadock WiAC
To change the default settings, you might need to adjust the audio settings
in Windows
■
If there is no audio device connected to the dynadock, the audio ports
on the computer are enabled automatically.
■
If your media player is running when you undock or dock, you must
close the application and wait approximately 10-15 seconds for the new
settings to take effect before restarting the application.
■
Audio devices connected to the dynadock via the 3.5 mm audio jack
appear as dynadock Audio device in Windows
■
When your computer is docked, SPDIF and Line in ports might display
in Windows
as "Currently unavailable" and are actually not provided by the
dynadock.

Configuring audio playback ports (Headphone)

1. Right-click the speaker icon in the Notification Area of your Windows
desktop.
(Sample Image) Speaker icon
If the speaker icon is not visible in the Notification Area, access the audio
configuration utility through the following Start menu:
In Windows
Sound.
In Windows 8.1, move the mouse pointer and click
lower-left corner of the screen to get to the Apps view, and then click
Control Panel -> Hardware and Sound -> Sound.
2. Select Playback Devices from the menu.
3. On the Playback tab of the dialog box, select one of the following:
■
■
There might be other Audio devices listed in the menu depending on the
model of your computer.
4. Click Set Default.
5. Click OK.
6. Connect your playback device to the jack you enabled in step 3.
EN-22
®
manually, as described in this section.
®
audio properties dialog boxes. These ports should appear
®
7, click Start -> Control Panel -> Hardware and Sound ->
A Realtek High Definition Audio device—to use the Headphone/
Line out jack of the docked computer (The Realtek High Definition
Audio is provided with some computers.)
A dynadock Audio device—to use the Headphone/Microphone
combo jack of the dynadock
®
.
icon in the
User's Manual
®