Wps Function; Troubleshooting - Toshiba dynadock WiAC User Manual

TM
dynadock WiAC

WPS function

While being used as an AP, the WPS button allows you to connect to the
Internet without a password.
1. Click the Internet icon in the Notification Area of your Windows
and connect to "dynadockWiAC_xxxxxx".
2. Press the WPS button for about 5 seconds and the connection is
completed.
WPS function can be used for only one user at a time.

Troubleshooting

Problem
AC adaptor does not
power the dynadock.
No video on the
monitors attached to
the HDMI port or the
DisplayPort on the
dynadock.
EN-30
Procedure
Check the connections to make sure that the power
cord/adaptor is firmly connected to the dynadock
and a working power outlet.
Check the condition of the cord and terminals. If the
cord is frayed or damaged it should be replaced,
while if the terminals are soiled, they should be
cleaned with a clean cotton cloth.
If the AC adaptor still does not power the dynadock,
you should contact TOSHIBA Support.
Make sure the computer is connected with the
dynadock.
Make sure that the video cable is tightly secured to
the video port in the dynadock and that the display
output setting of the monitor is set to the correct
mode.
This might be due to the monitor(s) supporting
higher resolutions than the dynadock is able to
support. Check the
in this manual for details.
If only one monitor is shown, while the other is not,
go to the Intel Graphics Control Panel to select the
output for the second monitor.
If three displays are plugged into the dynadock, only
a maximum of two external monitors are supported.
Configuring Video Ports
® desktop
section
User's Manual