Configuring Audio Ports - Toshiba dynadock WiAC User Manual

■
The name of the dynadock is displayed as "dynadockWiAC_xxxxxx",
which differs from models.
■
Some computers might not immediately recognize that the dynadock is
connected upon start-up. This is related to the computers BIOS start up
sequence but not a malfunction of the dynadock. If this occurs, do the
following:
1. Turn off the computer
2. Disconnect the dynadock from the computer.
3. Turn the computer back on.
4. Connect the dynadock to the computer once the operating system
Disconnecting/Undocking your computer
There are several ways to disconnect/undock you computer:
■
Directly unplug the cable from the computer if it is connected.
■
While connecting the dynadock wirelessly, right-click the UDS icon in
the Notification Area of your Windows
dynadockWiAC_xxxxxx".
■
While connecting the dynadock wirelessly, click the Internet icon in the
Notification Area of your Windows
"dynadockWiAC_xxxxxx".
If a USB storage device is connected to the dynadock, make sure that you
save the data located on the USB device, and then remove the USB device
first before undocking.

Configuring Audio Ports

You can play back or record audio either through the audio port of the
dynadock or the docked computer. However, you cannot use the audio
ports on the docked computer and on the dynadock at the same time.
Upon docking connection, the audio port on the dynadock might become
enabled and the audio ports on the computer disabled. When you undock
the computer, the audio ports on the computer are re-enabled
automatically.
User's Manual
of the computer has loaded.
®
desktop and select "Undock with
®
desktop and disconnect from
TM
dynadock WiAC
EN-21