Venting Systems; Full Reline With Outside Air - Horizontal; Fire Risk; Illustrations Reflect Typical Installations And Are For Design Purposes Only - Quadra-Fire MTVI-E2-MBK-C Installation Manual

MT VERNON E2 INSERT-C
5

Venting Systems

A. Full Reline With Outside Air - Horizontal
CAUTION
Never draw outside combustion air from:
• Wall, floor or ceiling cavity
• Enclosed space such as an attic or garage
Figure 16.1
NOTE:
In Canada, where passage through a wall or partition of com-
bustible construction is desired, the installation shall conform
to CAN/CSA-B365.
16

Fire Risk.

Inspection of Chimney:
• Masonry chimney must be in good condition.
• Meets minimum standard of NFPA 211
• Factory-built chimney must be a minimum 6 inch
(152mm) UL103 HT.
NOTE: Use metal plate around
exhaust vent pipe and seal all edges
with non-flammable insulation such
as fiberglass, mineral wool or
ceramic.
Do not use high temperature
caulking materials to seal any edge
to prevent future serviceability.
Outside Air
Termination
NOTE:
• Illustrations reflect typical installations and are FOR
DESIGN PURPOSES ONLY.
• Illustrations/diagrams are not drawn to scale.
• Actual installation may vary due to individual design
preference.
7082-150C
WARNING
January 4, 2018