Makita DTW284 Instruction Manual page 6

Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Indicating the remaining battery
capacity
1. Battery indicator
capacity is shown as the following table.
Battery indicator status
On
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
may have
malfunctioned.
1
Remaining battery
capacity
Off
50% to 100%
20% to 50%
Battery indicator status
On
NOTE:
remaining battery capacity, slightly pull the switch
trigger.
NOTE:
minute after releasing the switch trigger.
NOTE:
stops even with a recharged battery cartridge, cool
down the tool fully. If the status will not change, stop
using and have the tool repaired by a Makita local
service center.
NOTE:
this case, cool down the tool before operating again.
Switch action
1
1. Switch trigger
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
NOTE:
pulling the switch trigger for 3 minutes.
6 ENGLISH
Remaining battery
capacity
Off
0% to 20%