Diagnostic Monitor - Cisco ASR 14000 Series Command Reference Manual

diagnostic monitor

diagnostic monitor
To configure the health-monitoring diagnostic testing for a specified location, use the diagnostic
monitor command in administration configuration mode. To remove the specified command from the
configuration file and restore the system to its default condition, use the no form of this command.
Syntax Description
node-id
test {id | test-name}
disable
Defaults To view the default value for each test, use the show diagnostic content command when the diagnostic
image is first installed. The default may be different for each test.
Command Modes Administration configuration
Command History Release
Release 3.7.1
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
Use the diagnostic monitor command to enable or disable health-monitoring diagnostic testing for a
specified test at the specified location.
Use the disable keyword to disable a health-monitoring diagnostic test that is enabled by default. For
example, if test 1 is enabled by default, the disable keyword disables the diagnostic test. If the no form
of the command is used, the test is set to the default condition, which is enabled.
To specify a physical layer interface module (PLIM) node using the node-id argument, use the following
Note
notation: rack/PLslot-number/SP. For example, 0/PL1/SP. PLIM diagnostic tests are supported.
Task ID Task ID
diag
Cisco ASR 14000 Series Router Interface and Hardware Component Command Reference
HR-34
diagnostic monitor location node-id test {id | test-name} [disable]
no diagnostic monitor location node-id test {id | test-name} [disable]
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
Operations
read, write
Location to enable diagnostic monitoring.
Specifies diagnostic test selection. The following test selections are
available:
• id—Test ID, as shown in the show diagnostic content command.
• test-name—Name of the test.
Disables diagnostic monitoring for a specified location.
Diagnostics Commands on Cisco IOS XR Software
OL-17228-01