Cisco ASR 14000 Series Command Reference Manual page 36

diagnostic load
diagnostic load
To load an offline diagnostic image for integrated field diagnostics, use the diagnostic load command
in administration EXEC mode.
Syntax Description location node-id
autostart {basic | all}
Defaults
No default behavior or values
Command Modes Administration EXEC
Command History Release
Release 3.7.1
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
Use the diagnostic load command to load an offline diagnostic image used for integrated field
diagnostics. Loading a diagnostic image places the specified card out of service.
The time it takes to load a diagnostic image varies depending on the card. Use the show platform
command to determine if the image has been loaded and if the card has been placed out of service.
Note After the diagnostic image is loaded, use the diagnostic start location node-id test {id | all | basic |
non-disruptive} command to execute the tests.
Task ID Task ID
diag
Examples The following example shows how to load an offline diagnostic image:
RP/0/RP0/CPU0:router# admin
RP/0/RP0/CPU0:router(admin)# diagnostic load location 0/0/CPU0 autostart basic
Cisco ASR 14000 Series Router Interface and Hardware Component Command Reference
HR-32
diagnostic load location node-id [autostart {basic | all}]
Loads an offline diagnostic image for a specified location. All modules in the
specified slot are loaded with the offline diagnostic image.
(Optional) Starts running the diagnostic tests after the image has loaded. The
following options are available:
•
•
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
Operations
execute
basic—Runs basic tests
all—Runs all tests.
Diagnostics Commands on Cisco IOS XR Software
OL-17228-01