Table of Contents
Advertisement
ACCESS CODES
Access codes are used to open a door. Up to 50 access codes can be programmed for each
door or channel of the controller. The codes are held in slots or pigeonholes that are
numbered 01 through to 50. You can record access codes for these slots using the form at
the back of this manual.
Adding Access Codes
Press * to select a
new menu function.
Note: avoid duplicating access codes especially between the two channels e.g. '1 2 3 4' for
channel A and '1 2 3 4 5 6' for channel B.
REMOVING ACCESS CODES
Removing Individual Access Codes
Follow the same procedure as for adding access codes except after select the slot containing
the access code in question simply press * or #. This will clear the code contained at that slot.
Removing All Access Codes for Channel A and B
All access codes for channel A can be removed by removing power to the controller then
while holding the number 2 key apply power only releasing the key when a beep is heard from
the control unit.
Removing All Access Codes for Channel A
All access codes for channel A can be removed by removing power to the controller then
while holding the number 1 key apply power only releasing the key when a beep is heard from
the control unit.
Removing All Access Codes for Channel B
All access codes for channel A can be removed by removing power to the controller then
while holding the number 3 key apply power only releasing the key when a beep is heard from
the control unit.
Doc Number MAN0013
* 6 5 4 3 2 1
*1
0 6
1 2 3 4 5 6
*
#
Date 05/08/09 Issue 04
Enter Programming code
Select Menu 1,access code door A
Select Menu 5,access code door B
Enter Slot Number
To add or change code
Enter new access code.
To remove code
DO NOT enter a code
Press # to finish
Advertisement
Table of Contents
