Operation - Progeny 2059 User Manual

INDICATORS
A coloured indicator is provided for each channel. The colours of these indicators have the
following meanings.
SOUND
Sound is used to give the user additional feedback on the status of the controller and
progress during programming.
Continuous Two Tone, High Volume
Four Notes "Low – High - Low – High"
Two Notes "Low - High"
Two Notes "High - Low "
Single Short Note "High"
USING ACCESS CODES
Access codes can be four, five or six digits in length. To operate one of the channels simply
enter one of the programmed access codes for that channel. If a correct code is entered then
the LED indicator for that channel will change to green and the output relay will activate.
Access codes can be changed to indicate Duress. Note this feature must be enabled if
required. See "RESTORING FACTORY DEFAULT SETTINGS" later in this manual.
HOLDING A CHANNEL OPEN
If a channels lock timer is programmed for timed operation, the operator can override this and
hold the output open. To do this, simply enter the access code for that door. Once the output
is activated and the LED indicator is showing green, push and hold the 1 & 2 keys as a pair.
This will hold open channel A. Use the 2 & 3 keys for channel B. To cancel the latched state
of a channel simply enter a valid access code again.
TOGGLE MODE
If the lock time for a particular channel has been set to zero then each time a correct code is
entered for that door or the RQE input activated, the output relay will "Toggle" to the opposite
state. And stay in that new state until another code or RQE is detected.
Each channel has its own lock time thus either or both channels can be selected to "toggle" or
"timed" operation. One channel can be used to open a door, and the other channel used to
turn on and off a piece of equipment.
Doc Number MAN0013

OPERATION

LED Colour
Red
Green
Amber
Flashing Off
Short blink to Off
Sound
HOLD OPEN A
1 2 3
Date 05/08/09 Issue 04
Meaning
Lock Closed
Lock Open
PDO Alarm
Programming
Keyboard Key Push
Meaning
PDO Alarm
Programming Mode
Confirm Programming Change
Programming Error
Keyboard Key Push
HOLD OPEN B
1 2 3