Access Gateway Default Port Mapping; Regulatory Compliance - Brocade Communications Systems 8000 Hardware Reference Manual
Hide thumbs
Also See for 8000:
- Administrator's manual (168 pages) ,
- Reference manual (370 pages) ,
- Replacement procedure (6 pages)
Table of Contents
Advertisement
A
Access Gateway default port mapping
Table 14
TABLE 14
PIN
1
2
3
4
5
6
7
8
Access Gateway default port mapping
The Brocade 8000 contains 24 CEE ports configured as F_Ports in Access Gateway Mode. The
switch also contains Fibre Channel ports 0-7, which are configured as N_Ports when in Access
Gateway mode.
The following lists the factory-default F_Port to N_Port mapping for Access Gateway mode.
NOTE
CEE ports 8-31 are configured as F_Ports. Fibre Channel ports 0-7 are N_ports with failover and
failback enabled.
•
•
•
•
•
•
For more information on changing port mapping, managing ports., and default policy settings for
Access Gateway Mode, refer to the Access Gateway Administrator's Guide.
Regulatory compliance
This section describes the regulatory compliance requirements for the Brocade 8000. It contains:
•
•
•
•
•
•
40
lists the serial cable pinouts.
Serial cable pinouts
Signal
Not supported
Not supported
UART1_TXD
GND
GND
UART1_RXD
Not supported
Not supported
8-11 mapped to 0
12-15 mapped to 1
16-19 mapped to 2
20-23 mapped to 3
24-27 mapped to 4
28-31 mapped to 5
"FCC warning (US only),"
next
"KCC statement (Republic of Korea)"
"VCCI statement Japan"
on page 41
"Power cords (Japan Denan)"
"BSMI statement (Taiwan)"
"CE statement"
on page 42
Description
NA
NA
Transmit data
Logic ground
Logic ground
Receive data
NA
NA
on page 41
on page 42
on page 42
Brocade 8000 Hardware Reference Manual
53-1001234-04
Advertisement
Table of Contents
