Table of Contents
Advertisement
Care Department at the number(s) listed in your
Emission Control Warranty Statement. Remove
the kit from the engine and restore the engine to
its original factory configuration when running the
engine under 1500 m (5,000 ft). Do not operate an
engine that has been converted for high-altitude
use at lower altitudes; otherwise, you could
overheat and damage the engine.
If you are unsure whether or not your machine has
been converted for high-altitude use, look for the
following label
(Figure
Contents
Introduction ............................................................... 1
Safety ....................................................................... 3
General Safety ................................................... 3
Safety and Instructional Decals .......................... 3
Setup ........................................................................ 5
Installing the Upper Handle................................. 5
Installing the Chute ............................................. 5
Installing the Traction-Control Linkage................ 5
Installing the Chute-Control Rod ......................... 6
Connecting the Headlight Wire ........................... 6
Installing the Snow-Cleanout Tool....................... 6
Checking the Engine-Oil Level............................ 6
Checking the Tire Pressure................................. 7
Checking the Skids and Scraper ......................... 7
Drive ............................................................... 7
Product Overview ..................................................... 8
Operation .................................................................. 8
Before Operation ................................................... 8
Before Operation Safety ..................................... 8
Filling the Fuel Tank ............................................ 9
During Operation ................................................... 9
During Operation Safety ..................................... 9
Starting the Engine ............................................. 9
Shutting Off the Engine......................................11
Operating the Traction Drive ............................. 12
Operating the Speed Selector........................... 12
Operating the Auger/Impeller Drive................... 12
Operating the Quick Stick®............................... 13
Clearing a Clogged Discharge Chute ................ 14
Operating Tips ................................................. 14
After Operation .................................................... 15
3).
Figure 3
After Operation Safety ...................................... 15
Preventing Freeze-up after Use ........................ 15
Maintenance ........................................................... 16
Recommended Maintenance Schedule(s) ........... 16
Maintenance Safety.......................................... 16
Preparing for Maintenance ............................... 16
Checking the Engine-Oil Level.......................... 17
Scraper ......................................................... 17
Cable ............................................................ 18
Cable ............................................................ 18
Checking the Auger-Gearbox-Oil Level............. 19
Changing the Engine Oil ................................... 19
Lubricating the Hex Shaft.................................. 20
Replacing the Spark Plug ................................. 20
Adjusting the Discharge-Chute Latch................ 21
Replacing the Drive Belts.................................. 21
decal127-9363
Replacing the Headlight Bulb............................ 21
Storage ................................................................... 23
Storing the Machine.......................................... 23
Removing the Machine from Storage ................ 23
Troubleshooting ...................................................... 24
2
Hide quick links:
Advertisement
Table of Contents
