Operating The Traction Drive; Operating The Speed Selector; Operating The Auger/Impeller Drive - Toro 37797 Operator's Manual

Figure 23
5. Pull the recoil starter 3 or 4 times.
Note:
This helps prevent the recoil starter from
freezing up.
Operating the Traction
Drive
CAUTION
If the traction drive is not properly adjusted,
the machine may move in the direction
opposite of what you intended, causing injury
and/or property damage.
Carefully check the traction drive and adjust it
properly, if necessary; refer to
Operation of the Traction Drive (page 7)
more information.
Important:
If the machine moves when the
traction lever is in the released position, check the
traction cable; refer to
the Traction Cable (page 18)
to an Authorized Service Dealer for service.
1. To engage the traction drive, squeeze the left
(traction) lever to the handgrip
Checking the
Checking and Adjusting
or take the machine
(Figure 24).
2. To stop the traction drive, release the traction
lever.
Operating the Speed
Selector
The speed selector has 6 forward and 2 reverse
gears. To change speeds, release the traction lever
g016499
and shift the speed-selector lever to the desired
position (Figure
each speed selection.
Operating the
Auger/Impeller Drive
1. To engage the auger/impeller drive, squeeze
for
the right (auger/impeller) lever to the handgrip
(Figure
12
Figure 24
25). The lever locks in a notch at
Figure 25
26).
Figure 26
g001011
g001012
g001013