Table of Contents
Advertisement
What's on the Back Panel?
The back panel of your residential gateway provides ports, power, and reset
mechanisms. Refer to the following diagram for a description of the back panel.
1
Power—The Power port is where you will connect the power adapter that is
included in the box.
2
Power Switch—Use this switch to power on or off the device.
3
Phone 1-2—The Phone ports connect standard analog telephones to the device.
Internet—The Internet port connects to the Ethernet port on the DSL, fiber, or
4
cable modem.
5
Ethernet LAN 1-4—These Ethernet ports (1, 2, 3, 4) connect device to wired
computers and other Ethernet network devices.
6
USB—The USB port connects to a USB storage device, such as a USB hard drive
or flash disk.
7
Reset—The Reset button restores the device to its original factory settings by
pressing and holding down the Reset button for 5 seconds.
Note: The reset does not restore the voice settings to the factory defaults.
4038767 Rev A
What's on the Back Panel?
7
Advertisement
Table of Contents
