Lenovo RackSwitch G8272 Installation Manual page 50

50
RackSwitch G8272 Installation Guide
4. Set the new switch to use the serial number of the old unit. For example:
RS 8272 (config)# boot esn 1000001
where 1000001 is the serial number of your old unit.
Note: The serial number shown here is merely an example—use the actual serial
number recorded from your old G8272 unit.
5. Reset the switch using the following command:
RS 8272 (config)# reload
6. When prompted for confirmation, enter y. The switch will then reboot.
7. After the switch reboots, return to the command prompt and verify that the VPD
information is correct using the following command:
RS 8272> show sys-info
System Information at 0:11:46 Wed Nov 6, 2013
Time zone: America/US/Pacific
Daylight Savings Time Status: Disabled
Lenovo RackSwitch G8272
Switch has been up for 0 days, 17 hours, 10 minutes and 45 seconds.
Last boot: 0:06:32 Wed Nov 6, 2013 (reset from console)
MAC address: fc:cf:62:9d:2b:00 IP (If 1) address: 192.168.49.50
Management Port MAC Address: fc:cf:62:9d:2b:fe
Management Port IP Address (if 4): 192.168.50.50
Hardware Part No: 00D9853
Switch Serial No: Y030PZ23H00E
Manufacturing date:12/12
MTM Value: 1234-56X
ESN: 1000001
Software Version 7.6.1 (FLASH image1), active configuration.
Temperature MAC: 32 C, Threshold: 60 C
Temperature 10G PHY: 31 C, Threshold: 63 C
Temperature CPU: 27 C, Threshold: 55 C
Temperature Air Inlet: 24 C, Threshold: 53 C
Temperature 1G PHY: 32 C, Threshold: 54 C
Temperature Air Outlet : 32 C, Threshold: 56 C
Fan 1 : RPM=9000 PWM=100% Back-To-Front [J]
Fan 2 : RPM=9000 PWM=100% Back-To-Front [J]
Fan 3 : RPM=9000 PWM=100% Back-To-Front [J]
Internal Power Supply: On
Redundant Power Supply: Not Installed
Power Faults: ()
Fan Faults: ()
Service Faults: ()
For more information about using the switch interface, see the Application Guide
and Command Reference for your switch model and firmware version.