Masterbuilt 20070115 Assembly, Care & Use Manual page 9

7
4
19
13
25
11
ENSAMBLAJE
PASO 11
Coloque el tazón de agua
(19) bajo la última rejilla del
ahumador. Fije el protector
solar (7) sobre el panel de
control (4).
PASO 12
Coloque la bandeja de trozos
de madera (13) y la bandeja de
goteo (25) dentro del ahumador
como se muestra.
Inserte el cargador de trozos de
madera (24) en la parte lateral
del ahumador.
El ensamblaje está completo.
24
ASSEMBLY
17
20
TENSION NUT
5
A
2
STEP 5
Insert adjustable screw leg (20)
through bottom of side panel (17)
as shown, and into smoker body.
Repeat step on opposite side for
remaining adjustable screw leg.
Note: When unit is upright, set
adjustable screw leg height by
turning clockwise/counterclock-
wise, so that smoker is level.
Once level, secure leg positions
by tightening tension nuts.
STEP 6
Carefully position smoker as
shown.
A
Attach rear handle (5) to back of
smoker body (2) using phillips
screws (A) as shown.
Note: Do not lift unit by rear handle.
8