Advertisement
ASSEMBLY, CARE & USE MANUAL
WARNING & SAFETY INFORMATION
ELECTRIC SMOKER MODEL 20071011
Masterbuilt Manufacturing, Inc.
THIS PRODUCT IS FOR OUTDOOR USE ONLY
1 Masterbuilt Ct.
Columbus, GA 31907
Customer Service 1-800-489-1581
www.masterbuilt.com
Approximate assembly time : 15 minutes
Tool needed for assembly: Phillips Head Screwdriver
CARBON MONOXIDE HAZARD
WARNING
This manual contains important
Burning wood chips gives off carbon
information necessary for the proper
monoxide, which has no odor
and safe use of this unit.
and can cause death.
Read and follow all warnings
DO NOT burn wood chips inside homes,
and instructions before using
vehicles, tents, garages or any enclosed areas.
smoker and during use.
Use only outdoors where it is
Keep this manual for future reference.
well ventilated.
Some parts may have sharp edges
handle with care.
Failure to follow these warnings and instructions properly could result in personal injury or death.
Advertisement
Table of Contents
Related Manuals for Masterbuilt 20071011
Summary of Contents for Masterbuilt 20071011
- Page 1 ASSEMBLY, CARE & USE MANUAL WARNING & SAFETY INFORMATION ELECTRIC SMOKER MODEL 20071011 Masterbuilt Manufacturing, Inc. THIS PRODUCT IS FOR OUTDOOR USE ONLY 1 Masterbuilt Ct. Columbus, GA 31907 Customer Service 1-800-489-1581 www.masterbuilt.com Approximate assembly time : 15 minutes Tool needed for assembly: Phillips Head Screwdriver...
- Page 2 • Do not plug in electric smoker until fully assembled and ready for use. This expressed warranty is the sole warranty given by Masterbuilt and is in lieu of all other warranties, • Use only approved grounded electrical outlet.
-
Page 3: General Warnings And Safety Information
• Do not store electric smoker with HOT ashes inside unit. Store only when all surfaces are cold. • Accessory attachments not supplied by Masterbuilt Manufacturing, Inc. are not recommended and 1. Reorient or relocate the receiving antenna. -
Page 4: Let's Get Started
• Extreme cold temperatures may extend cooking times. • CLEAN AFTER EVERY USE. This will extend the life of your smoker and prevent mold and For more tantalizing recipes and cooking tips mildew. visit us online at www.masterbuilt.com ENJOY! WOOD SMOKING GUIDE FOR MEATS WOOD FLAVOR... - Page 5 DO NOT RETURN TO RETAILER STOP For Assembly Assistance, Missing or Damaged Parts • Maximum temperature setting is 275°F (135°C). Call: MASTERBUILT Customer Service at 1-800-489-1581. • Do NOT move unit across uneven surfaces. PARTS LIST • Rear handle is NOT for lifting.
-
Page 6: Hardware List
Refer to page 13 instructions Instruction Manual 9807100037 wrong Remote is not linked properly to Contact Masterbuilt at 1.800.489.1581 DO NOT RETURN TO RETAILER controller STOP For Assembly Assistance, Missing or Damaged Parts Remote malfunctioning Call: MASTERBUILT Customer Service at 1-800-489-1581. -
Page 7: Assembly
HOW TO USE CONTROL PANEL & REMOTE CONTROL ASSEMBLY • BEFORE ASSEMBLY READ ALL INSTRUCTIONS CAREFULLY. • ASSEMBLE UNIT ON A CLEAN, FLAT SURFACE. • TOOL NEEDED: PHILLIPS HEAD SCREWDRIVER STEP 1 Position wheel (5) on bottom of smoker body (1) as shown. Insert adjustable screw leg (4) *Batteries not into bottom of wheel (5). - Page 8 ASSEMBLY HOW TO USE CONTROL PANEL & REMOTE CONTROL STEP 3 Secure control panel (6) to smoker body (1) with phillips screws (A). Note: Do not over tighten. Note: Direct sunlight may interfere with ability to read LED display, block light if needed. To set temperature: •Press ON button.
- Page 9 PRE-SEASON INSTRUCTIONS ASSEMBLY STEP 5 Preseason smoker prior to fi rst use. Make sure water pan is in place with NO WATER. Set Slide cooking racks (13) onto temperature to 275°F (135°C) and run unit for 3 hours. Shut down and allow to cool. Some smoke may guides inside smoker.
- Page 10 ASSEMBLY ASSEMBLY STEP 7 STEP 9 Place wood chip tray (10) in Slide brackets on back of grease smoker as shown. tray (15) onto tabs on back of smoker body (1) until grease tray Note: Wood chip tray and wood stops.