Lcd Brightness Adjustment; Testing The Treadmill Operation - JLL T350 Instruction Manual

LCD BRIGHTNESS ADJUSTMENT

1. In STANDBY mode, press and hold the PAUSE/STOP button for 5-8 seconds. The
incline section will display the brightness level (from 7 to 20).
2. Adjust the brightness of the LCD display using the SPEED INCREASE or SPEED
DECREASE buttons.
3. Press QUICK START to save the adjustments.

TESTING THE TREADMILL OPERATION

Use the following instructions to test the full speed of the treadmill and to check the belt
for proper operation.
JLL recommends that the treadmill is unplugged or the On/Off power (I/O) is switched
®
off (O) when not in use.
1. Without anyone on the machine, plug the treadmill in. Ensure the power cable is not
being pinched under the front of the treadmill.
2. Locate the On/Off (I/O) power switch under the front end of the treadmill. Switch it
to the on position (I). The display will light up.
3. The weight digits will flash. Adjust the weight using the SPEED INCREASE and
SPEED DECREASE buttons located on the handrail.
4. Press QUICK START and the treadmill will start at 0.3 km/h. Check if the monitor is
working normally.
5. Observe the belt to see if it is running properly; it should be centred in the middle of
the deck. If you have problems with the running belt operation, see Adjust Running
Belt in the Preventive Maintenance chapter.
6. Press SPEED INCREASE and SPEED DECREASE to check whether they are
working. Run the treadmill through its full speed range. First press the SPEED
INCREASE button until the treadmill reaches its highest speed. Then press the SPEED
DECREASE button until the treadmill is back to 0.3 km/h.
7. Press the PAUSE/STOP button and check if the machine stops the workout.
WARNING: FALLING HAZARD
When starting the unit:
• Stand on the side frames.
• Do not stand on running belt.
14