Advertisement
References for Installation
Optional: Installing an RTN 360 on a Pole
Pass the hose clamps through the fastener and fix the hose
clamps on a pole using the screws of the hose clamps.
This side up
Optional: Installing an RTN 360 on a Wall
Press the fastener against a wall, level the installation location
using a level, and mark locating points using a marker.
1. Fastener
2. RTN 360
Drill holes and install expansion bolts at the locating points.
1. M6x60 bolt
2. Nut
3. Spring washer
4. Flat washer
5. Expansion sleeve
12/13 >>
Before fixing the hose clamps, ensure that the
azimuth faces the peer site.
Install the fastener onto the expansion bolts, place a flat washer, a
spring washer, and a nut on each expansion bolt, and then tighten
the nuts.
Ensure that each expansion bolt protrudes from 8
mm to 12 mm.
Install the RTN 360 box securely on the fastener.
Unscrew the azimuth
adjustment nut.
Hook the RTN 360 box (with the attachment plate
installed) to the fastener along the dowel.
Install the RTN 360 box securely on the fastener.
Unscrew the azimuth
adjustment nut.
Hook the RTN 360 box (with the attachment plate
installed) to the fastener along the dowel.
Tighten the azimuth
adjustment nut using a hex key.
Tighten the azimuth
adjustment nut using a hex key.
Advertisement
